Reply to thread

No molds for me anymore... I don't have the time to cast them, so the molds just end up being expensive shelf warmers :/


There haven't been any public images of the back or other side yet, so it's all guesswork. Sean's model has the mohawk / stripe going all the way to the bottom. I put the key slot in there to break it up a bit, but that's just wishful thinking that the actual rear would look like that.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top