Reply to thread

My gauntlets are very form fitting so I don't need any velcro to keep them in place but I did add a strip inside in case I needed it.


My Jango gauntlets are a little looser so I just added some padding inside and they don't spin around at all.


Don't use the dremmel as it will heat up your PLA and you will probably break the discs.  Use a fine toothed jeweller's saw that you can get at a hobby shop or even one of those under cut hand saws from a building supply store.


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top