Reply to thread

Hello guys.

I recently started to do some 3D modelling having a 3D printer so I decided to do a darksaber so I could change my toy one with a 3d printed model.

[ATTACH=full]145771[/ATTACH]

[ATTACH=full]145773[/ATTACH]

 

the model is 32 cm long which seems pretty ok to me.



Overall shot

[ATTACH=full]145775[/ATTACH]



top detail. sorry but the brackets needed all some sanding and I had not much time to spend on them today.

[ATTACH=full]145777[/ATTACH]



emitter detail

[ATTACH=full]145779[/ATTACH]



handle detail

[ATTACH=full]145781[/ATTACH]

 

What do you think?

 

F


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top