Reply to thread

[ATTACH=full]173030[/ATTACH] [ATTACH=full]173029[/ATTACH] Put together the newest version of Coz3D's 3D printed jetpack this past few weeks and started painting it.  It's not done, still have to put on the piano keys, beacon, decals and more weathering but maybe 95% complete at this point.  I have been making this one for my personal Fett mannequin but wanted to show some pics on where I am at this point.  It's been a breeze considering I have made two others as scratch builds.  I can't wait to get it finished and weigh it!  I think it's going to clock in at just 5 pounds![ATTACH]173029[/ATTACH] [ATTACH]173030[/ATTACH]


A Lot of the detail is lost in the pics but you get the general idea


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top