Reply to thread

Message

Can anyone advise on weathering? I know about the focussed areas like the dent powder burn and the area on the back panel, the lower cheeks e.t.c but aside from that, am I to just apply a general wash of ‘grime’? If so:

Do I do that before or after sealing with clear coat? If it’s after, do I apply another layer of clear coat on top of the weathering?

And, for that layer of general grime…

Is it just heavily diluted Matt black? Specific modeling wash? Acrylic? Enamel?

[QUOTE="Short4ATrooper, post: 521774, member: 16204"] Can anyone advise on weathering? I know about the focussed areas like the dent powder burn and the area on the back panel, the lower cheeks e.t.c but aside from that, am I to just apply a general wash of ‘grime’? If so: Do I do that before or after sealing with clear coat? If it’s after, do I apply another layer of clear coat on top of the weathering? And, for that layer of general grime… Is it just heavily diluted Matt black? Specific modeling wash? Acrylic? Enamel? [/QUOTE]

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification