Reply to thread

Marked out the light grey damage on the upper cheeks and front mandible areas before laying down the silver layer.


[ATTACH=full]220764[/ATTACH]

I think this was the worst time I’ve had with the templates so far. The dimensions of this helmet around the mandibles are just nowhere near. I did the best I could though and used references from the celebration album to match up the areas as best I could.


I also filled in and re-cut the physical damage as it wasn’t where it was supposed to be. You can faintly see the old cut just below the new one:


[ATTACH=full]220765[/ATTACH]


Ordinarily, I would t have stopped with repairing the old cut until you would never know it was there but I’m not going to be too precious with this build.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top