Reply to thread

Thanks mate, but it's not really working out. It came out ok with the back panels but once I got to pieces like the mandibles I realised i't not going to be a good enough solution.


Even once I get the templates to fit, their so distorted and pixellated I don't think I'll be able to see what I'm doing.


Is it possible to do it freehand? Just use the templates as reference and draw directly onto the helmet?


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top