Reply to thread

I’m in the U.K. so no hobby lobby here but I know what you mean. I’ve got lots of time to kill before my BM helmet turns up so there’s definitely no rush! My usual process with heavy print lines is to give them a good scuff with some super low grit sandpaper, like 60 or 80, before smoothing out with a 120. Then I give it a pass with some filler to take care of the deeper lines, sand that back with 400 and then a coat of spray putty which I sand with 800. Coming along nicely so far.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top