Reply to thread

I have a Bobamaker helmet on order, expected around March and since it’ll be my first time airbrushing, I figured I’d do a 3D printed one while I wait as a kind of practice run.


I got this on Etsy from a seller called 3DPingCrafts. Print is good, feels nice and sturdy. I ordered the raw kit so it needs a lot of sanding to get the print lines out. I didn’t take any pictures before I started but this is mid way through filling and sanding the dome. Back panels have been done and feel smooth as a baby’s bum.


An area of concern for me early on is the dent. I have no idea how I’m going to get in there and get those print lines out. I may be better off just going to town with filler and re-sculpting it. Or maybe the etching tool on my dremel? Don’t know yet.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top