Reply to thread

The way I figure it out is to run the parts through the slicer and document how much filament each part takes. Then add it all up and figure out how many rolls it will take to get the amount you need. I am sure there is an easier way, but this is how I do it.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top