Reply to thread

If it has 2 z axis stepper motors its the 10s. PETG needs to print a little slower than PLA so I have mine set at 40mm/s. I use Cura becasue I'm too cheap to spend $150 on Simplify3d.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top