Reply to thread

Would you be willing to share what settings you typically use to print armor at as well as the slicer info? I just picked up one of these off a buddy recently in a trade (though Im not sure if its the regular 10 or the 10S) and have a few projects I'd love to try doing on it.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top