Recent content by ObitomoFett

cheers :D I was able to trim down my armour to look similar to the gallery, I know another person mentioned to leave 3mm on. so to be on the safe side I left 4.5mm to allow for sanding etc.

As in leave that much on the curve on the piece? Sorry I don't follow. - - - Updated - - - As in the screenshot gallery?

To take that much off?

Hey guys and gal's. Recently received my kit of RS prop masters abs armour. But I'm not sure how to go about all the trimming and fitting? Does anyone have a general idea or have trimmed that specific armour on their build thread? I just don't want to cut too short etc on my pieces. I'm...

Hey Kelev, could I see what they look like open? Like on the inside of each clamshell?

Ended up purchasing Rs Prop Masters armour directly from them :)

What does it do?

Sick looking Mando! - - - Updated - - - Also surprised you didn't just repaint the gauntlets from your Mando?

Sawed my rocket down so it fit into my pack, so now I can take the rocket out and put it back in with ease. I have a different question though, mentioned in my post to begin with. Has anyone used oven cleaner to strip paint off a Fibreglass piece, or is the be all end all way just to grit my...

How's the build going man?

Both really, I meant to say both haha. I've heard the wing and nut set up is the best way so I think I'll do that.

Bought boots a while ago, just wondering what screws I should use for the toe spikes I have? As in what size and length etc.

Is there a specific way people put their rockets into their packs?

Not at all man :) I'm looking at getting them myself.

As it's pre painted a rough sand would suffice with the outside clean-up? Because obviously paints don't mix with paints so straight up painting the outside of the jetpack will cause paint cracking.