WTFett
Active Hunter
I'm starting to test fit all the JP pieces before I prime and attempt to paint this thing. It's a MOW pack and I have 3 questions:
1. Some parts have seams on them from the casting process, do you guys sand these seams down or leave them be?
2. Some parts have little chips. I'll probably leave some of them like the one on the thruster below (pic also shows a seam), but for other chips what can I use to fill them and then smooth it out? Will just a spot filler work? Any recommendations on what to get?
3. One or two parts have little bubbles. Again, I'm guessing a spot filler will take care of these?
Thanks!
1. Some parts have seams on them from the casting process, do you guys sand these seams down or leave them be?
2. Some parts have little chips. I'll probably leave some of them like the one on the thruster below (pic also shows a seam), but for other chips what can I use to fill them and then smooth it out? Will just a spot filler work? Any recommendations on what to get?
3. One or two parts have little bubbles. Again, I'm guessing a spot filler will take care of these?
Thanks!