HotPockets
Hunter
Hi Everyone,
Over the past 4 or 5 years I have been making screen accurate programmed Boba Fett Chest Displays. I was curious if there is community desire for a lower profile model made with surface mount electronics. This would allow you to have a much thinner version of the board, along with one that allows you to switch between the sequences from RotJ as well as ESB. It would cost a bit more to produce (about 25%). I was just checking if folks had interest before I invested in producing prototypes.
Thanks!
Over the past 4 or 5 years I have been making screen accurate programmed Boba Fett Chest Displays. I was curious if there is community desire for a lower profile model made with surface mount electronics. This would allow you to have a much thinner version of the board, along with one that allows you to switch between the sequences from RotJ as well as ESB. It would cost a bit more to produce (about 25%). I was just checking if folks had interest before I invested in producing prototypes.
Thanks!