mainst69
Active Hunter
Hey guys, I'm about to do some research on the tube on a problem I'm having with my airbrush. In a nutshell, if I tighten the hose on the airbrush to where it is finger tight and the connection is not leaking air, it seems to close up the air piston and make it where when you depress the trigger nothing happens. The only way I can get it to work is to loosen it about a quarter turn (the hose fitting) and then it will pass air. But the dang thing leaks like a sieve (sp?). I have a moisture trap that goes on the airbrush between the hose and the airbrush that has a little bleed valve to blow the moisture out of the line. It does it with that as well.
This is throwing a major kink in my build. Do any of you pro painters have any suggestions? I've tried lubing, cleaning, everything. I have not taken that inlet valve apart yet (I'm a wittle scawed!)
Any advice is appreciated.
Main
This is throwing a major kink in my build. Do any of you pro painters have any suggestions? I've tried lubing, cleaning, everything. I have not taken that inlet valve apart yet (I'm a wittle scawed!)
Any advice is appreciated.
Main