Crookknight
New Hunter
I have been working on the design for a couple of months. Going for the ESB Boba Fett Jetpack. I took this one to see if we could come up with a lightweight, durable, and cost effective alternative. All parts are 3D printed ABS and hollow. Once I have the pack assembled, I will weigh it, but it should be less than 10 lbs. Thinking it might be around 5 lbs. Since we are 3D printing we are able to increase the level of detail. I had been posting the progress on BHG, but was told I could get better feedback on this site. Plus, I will be building a ESB Boba Fett, myself. The next trick is going to be painting and weathering. Below are some of the 3D renderings and some of the parts that have just arrived.
Here are most of the pieces. Keep in mind, I have not glued or screwed any parts together yet.
Here are most of the pieces. Keep in mind, I have not glued or screwed any parts together yet.
Last edited: