Yeah, I can make the jumpers straight instead of at a right angle if that is a problem. The board + jumpers measures 1 1/8" in width right now. Again this is just a prototype so nothing is set in stone. On my original design, the jumpers were straight and they fit inside a hollow RF no problem. I just used some old header pins I had laying around.
The board does run off coin cell batteries, 3 of them. I am looking to put the battery springs on the board so the batts just sit on the other side of the board. Right now the board and batts will fit inside an RF as that is the same battery source I used before in my first version LED circuit (See here: http://www.hyperdynelabs.com/misc/fett_rf_guts.jpg).
I dont have my hollow RF anymore, so if someone can take internal measurements that would also help. It's been awhile since I messed around with one..
Thanks.
The board does run off coin cell batteries, 3 of them. I am looking to put the battery springs on the board so the batts just sit on the other side of the board. Right now the board and batts will fit inside an RF as that is the same battery source I used before in my first version LED circuit (See here: http://www.hyperdynelabs.com/misc/fett_rf_guts.jpg).
I dont have my hollow RF anymore, so if someone can take internal measurements that would also help. It's been awhile since I messed around with one..
Thanks.