General My armor

Thread starter Jerseyfett88
Start date Oct 6, 2015

Jerseyfett88

New Hunter

Oct 6, 2015

So I know I'm new, but I get a lot of free time at work where I have access to a lot of metal and a plasma cutter. Here is what I have so far. Hopefully going to paint the pieces soon as well as try to shape them properly.

All you see is 1/16" galvanized sheet metal that I cut and ground to shape using the Alan Sinclair templates I found on this site. Still haven't decided if I'm going to use plastic for the back piece to try to save my back a little. Still not sure how I'm going to attach it all though. I'm considering snaps but haven't decided yet.

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.