I just recently purchased a Fettronics light board for my chest armor, but now have a dilemma concerning the cut outs for it. When i bought my Boba, the cut outs were already there, and a sticker of the chest lights were there as a placeholder. Using a caliper, i measured the cut outs to be as follows: (Top hole): 5mm tall, 64mm wide (Bottom hole): 9mm tall, 64mm wide. According to Fettronics, the height is correct, but the length is only supposed to be 50mm wide! The cut outs don't appear to be the most evenly cut holes ever, and the gap in between the holes is only 4mm, when Fettronics calls for at least an 8mm gap! What should I do to correct this? Any ideas would be greatly appreciated!
Last edited by a moderator: