Reply to thread

Thanks fellas!


I may as well post up where I'm at with this today.


I'm working on a brush-on mold with tin cure silicone I ordered from raw material suppliers. It's pretty easy to work with...I did 1 other mold with it and had good results.


[ATTACH]57806[/ATTACH][ATTACH]57804[/ATTACH][ATTACH]57802[/ATTACH][ATTACH]57803[/ATTACH][ATTACH]57801[/ATTACH][ATTACH]57805[/ATTACH][ATTACH]57799[/ATTACH][ATTACH]57800[/ATTACH][ATTACH]57798[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top