Reply to thread

Thanks guys! That dent has been a big time sink for me just to get it right.


I figured I would share a little of my process at this point.


[ATTACH]57544[/ATTACH]

Here we have some problems with the left cheek and brow profile... I set up a photoshop comparison.


[ATTACH]57547[/ATTACH][ATTACH]57545[/ATTACH]

I glued on a template built it out with bondo. Yes, that is a pink slipper there. Someone was "helping" me.:lol:



[ATTACH]57546[/ATTACH]

Got my ears resin coated, sanded & primed. I had a local guy 3d print these. I've already had to modify once...I may need to again. My own fault for not double checking measurements.:facepalm


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top