Reply to thread

If this turns out like I want it to... I would be open to selling castings. 1st I'm going to test them out on a few friends and family who want a casting, and see how the fit and look is. I'll definitely hit you up when I can do some.


As far as the ears go, they will be block molds. I'll be starting the prototypes out on a cnc router with 3d print files. If the router performs well enough i'll make aluminum stalks like I did for my kid's buckets.


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top