Reply to thread

Message

I buy my resin from a plastics supply company but you should be able to find it at an auto parts store or boat supply shop. I chose to make a three piece mold & partitioned around the rangefinder earpice (so that came out as one section) because of the undercuts. The other partion was centered across to the other earpiece for a total of three sections. I did it this way because I was using a cheap medium for a mold & had no intention of making more than one or two casts. It worked fine & did the job.

[QUOTE="bigkidbiggertoys, post: 7734, member: 45"] I buy my resin from a plastics supply company but you should be able to find it at an auto parts store or boat supply shop. I chose to make a three piece mold & partitioned around the rangefinder earpice (so that came out as one section) because of the undercuts. The other partion was centered across to the other earpiece for a total of three sections. I did it this way because I was using a cheap medium for a mold & had no intention of making more than one or two casts. It worked fine & did the job. [/QUOTE]

This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification