Reply to thread

Yea but how many coats did yo ugive it in the end? xD


Oh also, beleive it or not, I have just found out somethign I have been doing wrong.. when applying bondo i was using a bend applier and I applied it top to bottom, where as I should have have used a straight applier and should have done it from side to side... no wonder the hollow areas were hardly filling up, gonna fille em up tommorow, end see if it has improved


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top