Reply to thread

So, would the plastic model survive one vacuum pull?


Yes, I didn't think about plaster. Any plaster would work I guess. Good idea. I make one pull of vacuum from the plastic model and then use the pull as a mold to cast another car in plaster. Then make all my vacuum pulls from the plaster model. Sounds like a great idea. Thanks a lot.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top