Reply to thread

Message

that's basically it yeah.. the plastic is glued together on the inside with hot glue, then filler is used on the outside (i used water based wood putty and bondo). there's a wood frame on the inside that i built out of hot glue and dowels to make it stronger while i was handling it.

i've never intended for the originals to be worn, so i wasn't worried about durability, just looks. they only have to survive the silicone to do their jobs

[QUOTE="stormtrooperguy, post: 179128, member: 597"] that's basically it yeah.. the plastic is glued together on the inside with hot glue, then filler is used on the outside (i used water based wood putty and bondo). there's a wood frame on the inside that i built out of hot glue and dowels to make it stronger while i was handling it. i've never intended for the originals to be worn, so i wasn't worried about durability, just looks. they only have to survive the silicone to do their jobs :) [/QUOTE]

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification