Reply to thread

Message

Jodo, same thing happend to my Green DP95 while I cut out the visor. Some JB weld from walmart will do the trick, I used 24hr cure, but if you get the 5-10 min cure JBweld, it will be wearable or be ready to paint again in no time. I just mixed some then opened the crack a tad, then put it in and put a generous amount on the inside of the helmet. Then I smoothed it out with my finger on the outside so it was flush. Let it cure, and if it has some excess you can sand it down.

[QUOTE="Gilmortar, post: 25987, member: 121"] Jodo, same thing happend to my Green DP95 while I cut out the visor. Some JB weld from walmart will do the trick, I used 24hr cure, but if you get the 5-10 min cure JBweld, it will be wearable or be ready to paint again in no time. I just mixed some then opened the crack a tad, then put it in and put a generous amount on the inside of the helmet. Then I smoothed it out with my finger on the outside so it was flush. Let it cure, and if it has some excess you can sand it down. [/QUOTE]

This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification