Reply to thread

Give me a little time and I will update my sales thread that I started the Flamethrower discussion in. Without a drill press you really dont want to drill int resin (as my messy test results attest to) you would not have been happy with the results.


Sent from my SM-G930V


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top