Reply to thread

That is something that will work on because in now some people are concerned about it. I didn't do it this time because I didn't find a case I really liked until after I had already drawn up the board and had the first small batch made.

I will be making some minor changes to the board soon so I may be able to see how it will fit into the enclosure I found once I draw it up in cad again.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top