Reply to thread

I will be leaving the servo attachment to the buyer due to the different helmet versions. The set screw method will work but finding a screw that is small enough to not interfere with the ear piece or the micro switch (if it's installed) is the main problem. I may end up leaving that up to the buyer too, but I plan on including the servo shaft extension with the kit, so that may help.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top