Reply to thread

Message

The set screw method would work the best but finding one small enough that won't interfere with either the micro switch or the ear piece or the ear piece it's self.
As for attaching the servo, leaving it up to the buyer is probably the best option. There are too many different helmets to try to make a one size fits all type of attachment method.

[QUOTE="Jc27, post: 385630, member: 5933"] The set screw method would work the best but finding one small enough that won't interfere with either the micro switch or the ear piece or the ear piece it's self. As for attaching the servo, leaving it up to the buyer is probably the best option. There are too many different helmets to try to make a one size fits all type of attachment method. [/QUOTE]

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification