sounding great!
If you havent figured out how to attach the stalk to the servo...heres the method i used previously.
on the back end of the circle part on the bottom of the stalk, you drill a small hole (from back to the center hole...through the thickness of the stalk) and mount a grub/set screw there. that will hold the stalk in place on the shaft extension. This is VERY easy to do on a resin stalk, and only slightly more difficult on an aluminum one, as you'll have to tap threads into the hole.
BTW i use this HiTec low profile servo
HS-77BB Low Profile
with this shaft attachment (make sure you get the one for the hitec servo):
Servo Shaft Attachment (.250")
The shafts are out of stack at the moment, but they restock fairly quickly and are great with customer service.
