Reply to thread

Message

Don't mind the mohawk. It looks much better when I put gel in it.

Finished up the grommetting on the vest, and put the last boxes on the front half of the belt.

[ATTACH=full]132447[/ATTACH]
[ATTACH=full]132448[/ATTACH]

I'm going to raise the bottom hem of the vest about 2 inches so its closer to the bottom of the chest and back armor plates. I also need some padding in the shoulders so they sit up a little higher.

Next on my to-do list is the back half of the belt, the small horns on the helmet, and attaching the thigh plates/holsters to the flightsuit.

[QUOTE="Naglium, post: 368957, member: 3446"] Don't mind the mohawk. It looks much better when I put gel in it. :) Finished up the grommetting on the vest, and put the last boxes on the front half of the belt. [ATTACH=full]132447[/ATTACH] [ATTACH=full]132448[/ATTACH] I'm going to raise the bottom hem of the vest about 2 inches so its closer to the bottom of the chest and back armor plates. I also need some padding in the shoulders so they sit up a little higher. Next on my to-do list is the back half of the belt, the small horns on the helmet, and attaching the thigh plates/holsters to the flightsuit. [/QUOTE]

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification