Reply to thread

Happy to get my girth belt in the mail today, now to get it the right color!


[ATTACH]57056[/ATTACH]


Ovation brand, "centaur non-slip mohair girth", B002HUR090, $35 on Amazon.


I can handle the staining part.  What's the best method to make the straps that go between the buckles?  Looks like in the film, one side was sewn, the other buckled.  Is that correct?  Thanks for any help.


[ATTACH=full]57056[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top