Reply to thread

Use Bondo to build up over the logo if its in the pipe and smooth it out via sanding. A couple of other suggestions would be maybe a fake sight post at the end of the barrel. You could also put a second barrel underneath for a grenade launcher.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top