Reply to thread

Hey guys!  I'm working on a cardboard helmet based off of WoF's templates and Antmans tutorial and I was hoping you could help me out with a quick question.  I bought a skate helmet and cut it down, but not sure if I cut it down enough?  If you can tell from the picture, I would love some feedback.  Its about 4" tall from the white part of the helmet.


[ATTACH]36213[/ATTACH]


Thanks,

Noah


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top