Reply to thread

The first step :

1 - Print the wood pattern

2 - Glue it on cardboard (i use an old playmobil box)

3 - Cut the differents shapes

4 - Draw the shapes on the plywood (see the second picture to optimize the material)

5 - Cut the shapes


[ATTACH=full]31339[/ATTACH]


[ATTACH=full]31340[/ATTACH]


[ATTACH=full]31341[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top