Reply to thread

Message

For fiberglass you will be hard pressed to get your hands on one for that price. I belive I got my first bucket (a SkyGunBro) for $175 plus shipping so not to far off from that. Its a good bucket and its large enough on me.
Dont quote me on that price though, its what I recall paying but like all bucket makers here, it cost what they want for it.

If your straped for cash I would go with a DP 95 and just mod it up. To do a bucket right the cost dose not end at buying the bucket, you then have sand paper, bondo, primer, paints, ect.... it adds up man. A DP 95 can be goten as low as $65 from what I have seen... I think I have seen them for a bit more on ebay as well. Hope that helps!

[QUOTE="evan4218, post: 76302, member: 1087"] For fiberglass you will be hard pressed to get your hands on one for that price. I belive I got my first bucket (a SkyGunBro) for $175 plus shipping so not to far off from that. Its a good bucket and its large enough on me. Dont quote me on that price though, its what I recall paying but like all bucket makers here, it cost what they want for it. If your straped for cash I would go with a DP 95 and just mod it up. To do a bucket right the cost dose not end at buying the bucket, you then have sand paper, bondo, primer, paints, ect.... it adds up man. A DP 95 can be goten as low as $65 from what I have seen... I think I have seen them for a bit more on ebay as well. Hope that helps! [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification