Reply to thread

I used Plastic Weld Epoxy.  It is made to adhere to the type of material the buckets are made out of.  Easy to use and apply, dries perm. hard in 15 minutes, and is super durable.  I used the inside 'tacking' method that is explained on tk409.com.  You only need to put a few dabs placed in strategic locations.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top