Reply to thread

Message

Gee, whose costumes might those be? *whistles innocently*

And it's shaping up like we're going to scratch-build the whole set, since my armor mechanic keeps coming up with comments like "You know, it would be really easy to sculpt out those hose connectors in resin..."

I did the top panels, and they were all kinds of easy. I cut the bottom layers out of a heavier Sintra sheet, wrapped them in leather, then cut the top plates out of a really thin plastic, cut the lettering into them, and I'm trying to get them rub n' buffed and weathered before I glue them to the bottom plate.

It's not hard, really!

Julie

[QUOTE="Iceheart, post: 71259, member: 539"] Gee, whose costumes might those be? *whistles innocently* And it's shaping up like we're going to scratch-build the whole set, since my armor mechanic keeps coming up with comments like "You know, it would be really easy to sculpt out those hose connectors in resin..." I did the top panels, and they were all kinds of easy. I cut the bottom layers out of a heavier Sintra sheet, wrapped them in leather, then cut the top plates out of a really thin plastic, cut the lettering into them, and I'm trying to get them rub n' buffed and weathered before I glue them to the bottom plate. It's not hard, really! Julie [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification