Reply to thread

Message

I am still obtaining all of the parts for my build but recently got my Wasted Fett gauntlets and have a question about the hose attachment options. What's the best way to attach the hose?

I have seen build photos where the larger hose is attached directly to the gauntlet (1st photo below) but I've read that it can cause issues as the larger hose isn't very flexible.

I have also seen the "floating" hose where a thinner, black hose or cable is connected to the gauntlet and ran through the larger hose. I picked up some smaller hose at Home Depot but the only way I could see to connect that smaller hose to the gauntlet would be to cut off the portion of the gauntlet that the larger hose fits onto and then maybe drill a hole in the gauntlet to feed the smaller hose into. Is there another way to do this with the WF gauntlet?

[ATTACH=full]200739[/ATTACH]

[ATTACH=full]200738[/ATTACH]

[ATTACH=full]200740[/ATTACH]

<blockquote data-quote="BobaFettAZ" data-source="post: 504821" data-attributes="member: 13964">I am still obtaining all of the parts for my build but recently got my Wasted Fett gauntlets and have a question about the hose attachment options. What&#039;s the best way to attach the hose? I have seen build photos where the larger hose is attached directly to the gauntlet (1st photo below) but I&#039;ve read that it can cause issues as the larger hose isn&#039;t very flexible. I have also seen the &quot;floating&quot; hose where a thinner, black hose or cable is connected to the gauntlet and ran through the larger hose. I picked up some smaller hose at Home Depot but the only way I could see to connect that smaller hose to the gauntlet would be to cut off the portion of the gauntlet that the larger hose fits onto and then maybe drill a hole in the gauntlet to feed the smaller hose into. Is there another way to do this with the WF gauntlet?[ATTACH=full]200739[/ATTACH][ATTACH=full]200738[/ATTACH][ATTACH=full]200740[/ATTACH]</blockquote>

[QUOTE="BobaFettAZ, post: 504821, member: 13964"] I am still obtaining all of the parts for my build but recently got my Wasted Fett gauntlets and have a question about the hose attachment options. What's the best way to attach the hose? I have seen build photos where the larger hose is attached directly to the gauntlet (1st photo below) but I've read that it can cause issues as the larger hose isn't very flexible. I have also seen the "floating" hose where a thinner, black hose or cable is connected to the gauntlet and ran through the larger hose. I picked up some smaller hose at Home Depot but the only way I could see to connect that smaller hose to the gauntlet would be to cut off the portion of the gauntlet that the larger hose fits onto and then maybe drill a hole in the gauntlet to feed the smaller hose into. Is there another way to do this with the WF gauntlet? [ATTACH type="full" width="394px"]200739[/ATTACH] [ATTACH type="full" width="395px"]200738[/ATTACH] [ATTACH type="full" width="394px"]200740[/ATTACH] [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification