Reply to thread

Message

Not too difficult, I imagine. I did all my paint misting without the hardware and visor in place, but there's no reason you couldn't do it after masking off those parts.

All the rest of the weathering is small-scale (with a small paintbrush and a towel), and you shouldn't even need to mask anything.

And yes-- I only have two sections left to write!

[QUOTE="CuteLucca, post: 151867, member: 2344"] Not too difficult, I imagine. I did all my paint misting without the hardware and visor in place, but there's no reason you couldn't do it after masking off those parts. All the rest of the weathering is small-scale (with a small paintbrush and a towel), and you shouldn't even need to mask anything. And yes-- I only have two sections left to write! [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification