Reply to thread

I used to use transfer paper, but had difficulty with it due to the two sets of paper and keeping it straight. I started using a method I got from [USER=303]superjedi[/USER]. I started printing out the color separated [USER=4963]RafalFett[/USER] templates onto tracing paper. I use a mechanical pencil on the reverse side of the paper and then once I set it in place, I trace the top side of the paper and it leaves the shape onto the helmet. The tracing paper is much easier to work with due to its thinness and since it is semi transparent, I find it easier to place it exactly where I want it. I believe superjedi has a tutorial here somewhere and can explain it better than I can.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top