Reply to thread

Christian told me he was going to be redoing some of those molds at some point in the future.

I can see your point and for a noob person doing this it can be a bit of a daunting task to fill it in. I've built 100's of resin things in the past and this is an easy one to do, 10-15 minutes worth of work sanding, primer, and some red glaze putty per part and it will be fine.

Lynn


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top