Reply to thread

I tried airbrushing a first layer but the humbrol clogged the airbrush so I have to clean it all.. Any advice on how I should use the paint? I think it's not made for air brushes so do you guys use something to make it more fluid or just water? Also I used the pipette to put the paint in the brush but not the pipette is full of paint and ruined...


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top