Reply to thread

Update: I followed your advice and attached another 3mm sintra piece and filled the gaps with bondo, then sanded it. A lot of work for 3mm haha.

I used primer to see where I'd need sanding, next step will be 1000 grit sand paper to make it perfectly smooth!


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top