Reply to thread

Really like this thread. What about using a very thin washer in between the visor and bucket to create a small gap. This would help with ventilation and fogging while not appearing to wide or separated from the bucket. Something maybe in the 1/32 thickness?


This thread is more than 60 days old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top