Reply to thread

Too true. I gave it a good sanding with a low grit but I think the pressure of the lense with its current stiffness attributed mostly to it popping the screw. One sxrew held though. So it may just be the the interior on that side.


This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top