Reply to thread

All I can say... Hot glue is not working out for me with the Chicago screws.


Works great visor to bucket. "Spot glued" (like a spot weld) to hold in place while the Chicago screws set. The screws ended up coming loose while the spot glue points held. Go figure. So, gonna use an apoxy instead. A little stronger I'm hoping.


Reason for the intent on the Chicago screws is that I'm putting two visors on for the install. Both with a lower tint. Stacked they will be nice and dark. But the easy removal and split visors will allow me to have a solid tint for day, then if night hits and I'm still out, I can quickly remove one lense and have proper tint for low light.



Sent from my iPhone


This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top